Removing Polystyrene Ceiling Tiles

Then wet the adhesive with warm water leave to soak for 10 mins use a heavy duty scraper with a sharp blade a quicker way is to use a wallpaper stripper.

Removing polystyrene ceiling tiles. The ceiling tiles attach directly to the existing ceiling using an adhesive. Then ceiling needs to be bonded with a pva such as unibond then plaster useing two coats lay first coat on as tidy as poss then close in with top coat and trowel to a smooth finsh make sure you run water brush round all angles so they are nice and clean and smooth hope some help kind regards col. Polystyrene tiles used to cover ceiling in bedroom image courtesy of homedecorinterior info. Remove as much in the way of furniture and accessories from the room as is reasonably possible.

Use the scraper to remove the adhesive off the ceiling. Removing polystyrene tiles or styrofoam tiles as they are sometimes known from walls or ceilings can be a tedious job and unfortunately there is no easy way of doing it other than getting stuck in with a wide scraper to scrape the tiles off. The beauty is that there are a number of different patterns available and they are not expensive. To help the process along you can jiggle the scraper up and down a little to prise the tiles away.

Step 1 removing the tiles. Because of different glues available to install polystyrene ceiling tiles. Use the steam to loosen the adhesive that remains on the ceiling. Cover everything remaining including the floor with tarps or plastic sheeting to help contain the polystyrene mess you re about to create.

Installing styrofoam ceiling tiles is one of the easiest ways to change an ugly ceiling into a beautiful one. Your aim here is to break the bond between the tiles and the glue or adhesive holding them up. Hi remove tiles just bye scraping of next scrap of as much tile adehesive as poss. Save yourself the arm pain by over stretching on a ladder and attempting to push these tiles off the ceiling in a jerky back and forth motion instead take a wide scraper and use a hammer to gently but forcefully break the bond between the tile and glue pushing them down from the ceiling as you go.

Tap it as far under the tile as you can using your hammer.